A composite B-spline method for cutter path generation on free-form surfaces

Authors:
Zhu Taosheng;Y. S. Wong;M. A. Mannan
Affiliations:
Mechanical and Production Engineering Department, National University of Singapore, Singapore.;Mechanical and Production Engineering Department, National University of Singapore, Singapore.;Mechanical and Production Engineering Department, National University of Singapore, Singapore
Venue:
International Journal of Computer Applications in Technology
Year:
2005

Citing 9
Cited 0

Geometric modeling

Geometric modeling
NC machining of free form surfaces

Computer-Aided Design
Curve and surface constructions using rational B-splines

Computer-Aided Design
Compound surface modelling and machining

Computer-Aided Design
Ball-end cutter interference avoidance in NC machining of sculptured surfaces

Computer-Aided Design
Tool-path generation in manufacturing sculptured surfaces with a cylindrical end-milling cutter

Computers in Industry
A computer-aided prototype system for NC rough milling of free-form shaped mechanical part-pieces

Computers in Industry
The NURBS book

The NURBS book
Adaptive isocurve-based rendering for freeform surfaces

ACM Transactions on Graphics (TOG)

Quantified Score

Hi-index	0.00

Visualization

Abstract

This paper presents a composite B-spline method for cutter path generation on free-form surfaces on a point-by-point basis, with appropriate radial offset and interference checking along the cutter path. It is aimed at developing a more efficient and accurate free-form surface machining method for an open-architecture CNC system with B-spline interpolation capability. In this method, the cutter paths over the free-form surface are composed of a sequence of B-spline segments. The length of each spline segment is determined by the desired deviation, within some given tolerance, from the curve of the surface over which the cutter path is to be generated. If the spline segment does not satisfy the specified dimensional tolerance, control points of the spline segment are adjusted to modify the curve shape according to the required accuracy. As a result, the deviation between the actual cutter paths and the desired surface curves will always fall within the allowable tolerance. In addition, by adjusting the position of the control points, the adjacent spline segments are made at least C1 geometrically continuous. The distance between adjacent cutter paths in the side step direction is determined by checking the scallop height between them. To make the cutting process more efficient, a modified adaptive iso-parametric curve generation approach is employed. The resulting cutter paths are more compact and accurate compared with those from commonly used cutter path generation techniques.