Design of Amplitude and Phase Modulated Signals for Differential Space-Time Block Codes
Wireless Personal Communications: An International Journal
Differential space time block codes using nonconstant modulus constellations
IEEE Transactions on Signal Processing
Multiple transmit antenna differential detection from generalized orthogonal designs
IEEE Transactions on Information Theory
A simple transmit diversity technique for wireless communications
IEEE Journal on Selected Areas in Communications
A differential detection scheme for transmit diversity
IEEE Journal on Selected Areas in Communications
Wireless Personal Communications: An International Journal
Wireless Personal Communications: An International Journal
| Hi-index | 0.00 |
Differential Space-Time Block Codes (DSTBC) do not require any radio channel measurement and channel state information neither on the transmitter nor at the receiver side. Therefore, they are an attractive alternative to coherent Multiple-Input Multiple-output (MIMO) systems. The classical technical proposal for differential techniques is based on M-ary phase shift keying (M-PSK) modulation schemes for DSTBC (PSK-DSTBC). One advantage of this scheme is the constant envelop of the transmit signal, but it is well known that higher-order PSK is less efficient due to the small distance between adjacent points in the constellation diagram. Therefore, in this paper an alternative modulation technique for DSTBC is discussed, which is based on quadrature amplitude modulation (QAM-DSTBC). The signal envelope of the transmit signal is not any more constant in this case. Therefore, the technical challenge of integrating QAM into the DSTBC system design is to control the transmit power in order to avoid an increase or a decrease in transmit power to some extreme values. The mechanism, which is used in this paper to control the transmit power is based on an extension of the original QAM constellation diagram. The additional points, which are integrated into the constellation diagram are used in this case for the mapping procedure to select one of the modulation symbols with high or alternatively low signal power. This means for each single bit pattern there are almost always two modulation symbols available in the mapping procedure one with low and one with high signal power, which gives the basis for a signal power control algorithm. The resulting bit-error-rate (BER) performance of QAM-DSTBC is compared finally to the performance figures of the original proposal of PSK-DSTBC.