Computer-aided machine-tool selection based on a Fuzzy-AHP approach
Expert Systems with Applications: An International Journal
Selection of layered manufacturing techniques by an adaptive AHP decision model
Robotics and Computer-Integrated Manufacturing
Make-to-order or make-to-stock decision by a novel hybrid approach
Advanced Engineering Informatics
Computers and Operations Research
Risk evaluation in failure mode and effects analysis using fuzzy weighted geometric mean
Expert Systems with Applications: An International Journal
The Evaluation for Cooperative Partner Selection Based on TFN-AHP
FSKD '08 Proceedings of the 2008 Fifth International Conference on Fuzzy Systems and Knowledge Discovery - Volume 05
| Hi-index | 0.01 |
Traditional FMEA (failure mode and effect analysis) analysis has some drawbacks so that affect the risk evaluation and correction action. It is very difficult for three risk factors to be evaluated precisely. Simultaneously, traditional FMEA doesn't consider the relative importance of three risk factors. The critical problem is that same RPN (risk priority number) can be obtained by different combination of three risk factors. So, the fuzzy logic is introduced into traditional FMEA to solve above problems. The rating of three factors is expressed as triangular fuzzy number and the relative importance among O (occurrence), S (severity) and D (detection) is also considered as triangular number, so the new fuzzy FMEA method is presented. In calculating the risk priority of failure modes, introduces α cut and satisfactory index β to obtain crisp number by defuzzification. So the failure mode with maximum risk priority is identified to correct. Finally, this method is applied in the risk evaluation of boiler tube.