Convergence analysis of downstream VDSL adaptive multichannel partial FEXT cancellation

Authors:
Itsik Bergel;Amir Leshem
Affiliations:
School of Engineering, Bar Ilan University, Ramat-Gan, Israel;School of Engineering, Bar Ilan University, Ramat-Gan, Israel and Dept. of EEMCS, Delft University of Technology, Delft, The Netherlands
Venue:
IEEE Transactions on Communications
Year:
2010

Citing 7
Cited 0

Matrix analysis

Matrix analysis
Partial crosstalk precompensation in downstream VDSL

Signal Processing - Signal processing in communications
Crosstalk models for short VDSL2 lines from measured 30MHz data

EURASIP Journal on Applied Signal Processing
Finite word length effects on transmission rate in zero forcing linear precoding for multichannel DSL

IEEE Transactions on Signal Processing
A Low Complexity Linear Precoding Technique for Next Generation VDSL Downstream Transmission Over Copper

IEEE Transactions on Signal Processing
FEXT cancellation for twisted-pair transmission

IEEE Journal on Selected Areas in Communications
Vectored transmission for digital subscriber line systems

IEEE Journal on Selected Areas in Communications

Quantified Score

Hi-index	0.00

Visualization

Abstract

In this paper we analyze an adaptive downstream multichannel VDSL precoder that is based on error signal feedback. The analysis presents sufficient conditions for precoder convergence and an upper bound on the precoder steady state error. The paper also considers and analyzes the case of partial FEXT cancellation. The analysis shows that in some scenarios (and in particular in mixed-length binders) the use of partial FEXT cancellation is crucial to achieve precoder convergence in a reasonable time. Based on this analysis we determine that convergence is achievable in most practical channels. These bounds also allow for the proper setting of the convergence parameters. The paper presents several simulations to demonstrate the theoretical results. In these simulations, setting the precoder parameters according to the analysis leads to convergence in less than 400 OFDM symbols.