Modeling simulations and instrumentation of high pressure roller crusher for the silicon carbide production

Authors:
Sylvester Sedem Djokoto;Hamid Reza Karimi
Affiliations:
Department of Engineering, Faculty of Engineering and Science, University of Adger, Grimstad, Norway;Department of Engineering, Faculty of Engineering and Science, University of Adger, Grimstad, Norway
Venue:
GEMESED'11 Proceedings of the 4th WSEAS international conference on Energy and development - environment - biomedicine
Year:
2011

Citing 4
Cited 0

Robust industrial control: optimal design approach for polynomial systems

Robust industrial control: optimal design approach for polynomial systems
Control System Design

Control System Design
Linear Feedback Control: Analysis and Design with MATLAB (Advances in Design and Control)

Linear Feedback Control: Analysis and Design with MATLAB (Advances in Design and Control)
Brief Single-loop controller design via IMC principles

Automatica (Journal of IFAC)

Quantified Score

Hi-index	0.00

Visualization

Abstract

This paper describes the modeling, simulation and the instrumentation of High Pressure Roller Crusher (HPRC) for the production of silicon carbide grains. The study is to make a model and then simulate a High Pressure Roller Crusher. Selection of sensors for the HPRC is also important in this study. A High Pressure Roller Crusher (HPRC) is an important part in the production of silicon carbide, where the grains are crushed into powder form and then sieved into specified sizes based on its usage. This paper will present a model based on Johanson's theory for roller compactors, considering all the delays. The non-linearity or delays were handled in matlab using. Conclusions were drawn at end of the paper.