Design of a full-band CMOS UWB receiver and fast-hopping carrier generator for 3.1---10.6 GHz

  • Authors:
  • Bong-Hyuk Park;Jae-Ho Jung

  • Affiliations:
  • Mobile RF Research Team, Mobile Communications Research Division, Electronics and Telecommunications Research Institute (ETRI), Daejeon, Korea 305-700;Mobile RF Research Team, Mobile Communications Research Division, Electronics and Telecommunications Research Institute (ETRI), Daejeon, Korea 305-700

  • Venue:
  • Analog Integrated Circuits and Signal Processing
  • Year:
  • 2014

Quantified Score

Hi-index 0.00

Visualization

Abstract

This paper presents an interference rejection full-band UWB receiver and fast hopping carrier generator for 3.1---10.6 GHz. This receiver enables 11 bands of operation by embedding a tunable notch filter to eliminate interferers in a 5 GHz wireless local area network. The carrier generator can cover 3.1---10.6 GHz within less than 9.5 ns. The receiver, based on the proposed multi-band OFDM standard, consists of a zero-IF receive chain and required system noise figure, the receiver linearity specifications of which are discussed in this paper. It consists of a single-ended low-noise amplifier (LNA), a down-conversion mixer, a low-pass filter (LPF), and a programmable gain amplifier with an IO buffer. The LNA employs a common-gate topology of the 1st stage with dual-resonant loads, a cascade amplifier of the 2nd stage for mid-band resonance, and a tunable notch filter. The down-conversion mixer adopts a single-balanced architecture with LO cancellation. The LPF is implemented based on an active RC topology, and implements a four-stage programmable gain amplifier. The receiver dissipates 49.3 mA from a 1.8 V power supply. The average voltage conversion gain of the receiver IC is 73.5 dB, and the system noise figure is 8.4 dB. Input P1dB increases from 驴36.8 dBm at 4 GHz to 驴30.5 dBm at 10.3 GHz. The attenuation is 8.5 dB, which is achieved in the interference rejection band at 5.2 GHz. It occupies an area of 0.98 脳 3.3 mm2 including the bond pads.