Capacity and flow assignment issues in MPLS networks

Authors:
Xian Liu
Affiliations:
Department of Systems Engineering, University of Arkansas at Little Rock, Little Rock, AR
Venue:
International Journal of Network Management
Year:
2003

Citing 10
Cited 1

Data networks (2nd ed.)

Data networks (2nd ed.)
Optimal capacity and flow assignment for self-healing ATM networks based on line and end-to-end restoration

IEEE/ACM Transactions on Networking (TON)
Restoration strategies and spare capacity requirements in self-healing ATM networks

IEEE/ACM Transactions on Networking (TON)
Computer networks: a systems approach

Computer networks: a systems approach
MPLS: technology and applications

MPLS: technology and applications
Introduction to ATM Design and Performance: With Applications Analysis Software

Introduction to ATM Design and Performance: With Applications Analysis Software
Network optimization with stochastic traffic flows

International Journal of Network Management
Labeled optical burst switching for IP-over-WDM integration

IEEE Communications Magazine
Generalized multiprotocol label switching: an overview of routing and management enhancements

IEEE Communications Magazine
Multiprotocol lambda switching: combining MPLS traffic engineering control with optical crossconnects

IEEE Communications Magazine

Survivable ATM mesh networks: Techniques and performance evaluation

Journal of Systems and Software

Quantified Score

Hi-index	0.02

Visualization

Abstract

MPLS technology enables IP networks to accept the challenge raised by emerging communication paradigms. This paper describes a nonlinear model with path capacity as design variables and space priority as constraints. The analysis shows that the close-form solution exists if traffic flows are allocated by an independent protocol.