Implications of passive mixer transparency for impedance matching and noise figure in passive mixer-first receivers

Authors:
Caroline Andrews;Alyosha C. Molnar
Affiliations:
Cornell University, Ithaca, NY;Cornell University, Ithaca, NY
Venue:
IEEE Transactions on Circuits and Systems Part I: Regular Papers - Special section on 2009 IEEE system-on-chip conference
Year:
2010

Citing 0
Cited 2

A 0.1---4 GHz SDR receiver with reconfigurable 10---100 MHz signal bandwidth in 65 nm CMOS

Analog Integrated Circuits and Signal Processing
Electronically scanned RF-to-bits beam aperture arrays using 2-D IIR spatially bandpass digital filters

Multidimensional Systems and Signal Processing

Quantified Score

Hi-index	0.00

Visualization

Abstract

In this paper, a class of passive mixer-first, LNA-less receivers is analyzed in depth. Quadrature passive mixers are shown to present the impedance of their baseband port to the RF port and vice versa. This transparency property, in combination with resistive feedback differential amplifiers, and "complex" feedback between the I and Q paths, can be used to control the impedance at the RF port. This impedance can be tuned using only baseband components (i.e., resistors). The noise limits of such an architecture are analyzed and simulated, and are shown to be comparable to standard RF-LNA-first receivers. Accounting for the higher harmonics of the LO frequency proves critical in accurately analyzing the behavior of these circuits and their ability to provide an impedance match with low noise figure. Additionally, it is shown that expanding quadrature passive mixers to harmonic rejection mixers allows for even better noise performance and wider matching range.