An improved soft-error rate measurement technique
IEEE Transactions on Computer-Aided Design of Integrated Circuits and Systems
False Error Vulnerability Study of On-line Soft Error Detection Mechanisms
Journal of Electronic Testing: Theory and Applications
MICRO '43 Proceedings of the 2010 43rd Annual IEEE/ACM International Symposium on Microarchitecture
Hi-index | 0.00 |
Soft error due to ionizing radiation is emerging as a major concern for future technologies. The measurement unit for failures due to soft errors is called Failure-In-Time (FIT) that represents the number of failures encountered per billion hours of device operation. FIT rate measurement is time consuming and calls for accelerated testing. There are multiple ways to accelerate soft error rate (SER) testing. Acceleration by increasing radiation and lowering supply voltage has been reported. In this paper we propose increasing the rate of failure due to soft error by intelligent pattern selection. The proposed approach is based on the fact that all circuit nodes are not equally susceptible to faults due to soft error. We propose a pattern selection technique which specifically targets the most vulnerable nodes in the circuit and construct a test set to maximize failure rate due to soft error. The solution is based on a combination of ILP and fault simulation techniques. The test set thus derived can be applied repeatedly to accelerate the soft error rate testing. Results based on ISCAS circuits show that it is possible to achieve 10X acceleration by this technique.