Continuous-time delta-sigma modulators for high-speed A/D conversion: theory, practice and fundamental performance limits
Analysis and Design of Analog Integrated Circuits
Analysis and Design of Analog Integrated Circuits
A 1-GHz, multibit, continuous-time, delta-sigma ADC for Gigabit Ethernet
Microelectronics Journal
Parallel continuous-time ΔΣ ADC for OFDM UWB receivers
IEEE Transactions on Circuits and Systems Part I: Regular Papers
Detailed analysis of the effect of a hysteretic quantizer in a multibit, Sigma-Delta modulator
Microelectronics Journal
A 1.2V, 130nm CMOS parallel continuous-time ΣΔ ADC for OFDM UWB receivers
Microelectronics Journal
Contribution to the modeling of a non-ideal Sigma-Delta modulator
Journal of Computational Electronics
Hi-index | 0.00 |
A comprehensive study of the impact of the finite gain-bandwidth product (GBW) in amplifiers and the excess loop delay on CT @S@D modulators has been carried out in this paper. Variations in the modulator coefficients have been included too. Considering a second order modulator, our study was based on the dependence of the NTF poles and zeroes locus in the z-plane on these two non-ideal effects from both an analytical and a computer simulation approach. The corresponding STFs were also analytically evaluated. The theoretical and the simulated results have been compared with the experimental results obtained from a test-chip recently designed and implemented. Amplifiers were modeled according to a single-pole transfer function. Using the modified Z-transform method the dependence of the NTF poles and zeroes locus in the z-plane on the finite GBW and on excess loop delay was obtained when the DAC pulse end occurs in the current (''early'') or in the following (''late'') clock cycle. Once the theoretical analysis was validated, NTF poles and zeroes loci were evaluated as a function of the two non-ideal effects considered separately or combined. In each case, the order of the modulator loop filter was discussed. The finite GBW effect can be compensated including an intentional ''early'' DAC pulse. This pulse can be implemented in the modulator by changing the sampling instant in the embedded ADC with respect to the instant DACs are enabled by using a simple delay circuit for the ADC clock. Thus, the modulator power consumption can be significantly reduced.