Serial-data computation
Digital integrated circuits: a design perspective
Digital integrated circuits: a design perspective
Digit-Serial Computation
Static and dynamic power reduction by architecture selection
PATMOS'06 Proceedings of the 16th international conference on Integrated Circuit and System Design: power and Timing Modeling, Optimization and Simulation
| Hi-index | 0.00 |
This paper focuses on leakage reduction at architecture and arithmetic level. A methodology for considerable reduction of the static power consumption is shown. Simulations are done in a typical 130nm CMOS technology. Based on the simulation results, the static power consumption is estimated and compared for different filter architectures. Substantial power reductions are shown in both FIR-filters and IIR-filters. Three different types of architectures, namely, bit-parallel, digit-serial, and bit-serial structures are used to demonstrate the methodology. The paper also shows that the relative power ratio is strongly dependent on the used word length; that is, the gain in power ratio is larger for longer word lengths. A static power ratio at 0.48 is shown for the bit-serial FIR-filter and a power ratio at 0.11 is shown in the arithmetic part of the FIR-filter. The static power ratio in the IIR-filter is 0.36 in the bit-serial filter and 0.06 in the arithmetic part of the filter. It is also shown that the use of storage, such as registers, relatively the arithmetic part, affects the power ratio. The relatively lower power consumption in the IIR-filter compared to the FIR-filter is due to the lower use of registers.