Signal delay in RC tree networks
DAC '81 Proceedings of the 18th Design Automation Conference
Multilevel routing with antenna avoidance
Proceedings of the 2004 international symposium on Physical design
Coupling aware timing optimization and antenna avoidance in layer assignment
Proceedings of the 2005 international symposium on Physical design
An exact jumper insertion algorithm for antenna effect avoidance/fixing
Proceedings of the 42nd annual Design Automation Conference
Post-routing redundant via insertion for yield/reliability improvement
ASP-DAC '06 Proceedings of the 2006 Asia and South Pacific Design Automation Conference
Proceedings of the 2006 international symposium on Physical design
Optimal jumper insertion for antenna avoidance under ratio upper-bound
Proceedings of the 43rd annual Design Automation Conference
Multilevel routing with jumper insertion for antenna avoidance
Integration, the VLSI Journal
Post-routing redundant via insertion and line end extension with via density consideration
Proceedings of the 2006 IEEE/ACM international conference on Computer-aided design
An optimal simultaneous diode/jumper insertion algorithm for antenna fixing
Proceedings of the 2006 IEEE/ACM international conference on Computer-aided design
Routing for manufacturability and reliability
IEEE Circuits and Systems Magazine
Discharge-path-based antenna effect detection and fixing for X-architecture clock tree
Integration, the VLSI Journal
| Hi-index | 0.00 |
This paper describes three ways to fix antenna problems: (1) diode dropping, (2) jumper insertion, and (3)diode dropping with extension wires.Basic principles of these methods are compared and results are presented. Diode structures, SPIC simulation, and diode slicing are also discussed in this paper.